The phrase "a tolerance between" is correct and usable in written English.
It can be used when discussing the acceptable range or degree of variation between two or more entities, such as measurements, opinions, or behaviors.
Example: "There should be a tolerance between the two measurements to ensure accuracy in the results."
Alternatives: "an allowance between" or "a margin between".
In rice, the OsHKT1 5 gene has been identified, based on the influence of the shoot K+ content (SKC1) locus on the K+ accumulation in xylem sap and shoots during salinity stress, as one of the primary genes causing a difference in salt tolerance between a tolerant indica cultivar Nona Bokra and a susceptible japonica cultivar (Ren et al. [2005]).
Given a tolerance of between 10 and 15% of the Luminex assay in our experiments, this sample may or may not reach a cut-off of 1000 if retested.
To guarantee the accuracy of the FE results, a sensitivity analysis was performed with a mesh refinement in order to achieve a convergence towards a minimum of the potential energy, with a 1% tolerance between consecutive meshes, for both the healthy and implanted models.
Zeta potential analyses were carried out by using a Coulter Beckman Delsa 440SX at 25°C with a 0.4°C tolerance between upper and lower sensors.
One missed cleavage per peptide was allowed and a mass tolerance between 0.3 and 0.1 Da was used in all searches.
For wood and painted wooden sculptures this area has been set between 19 and 24°C as regards temperature, with a tolerance of 1,5°C, and between 50 and 60% as regards relative humidity (RH%), with a tolerance of 4%.
The final mesh was achieved after a mesh refinement performed considering convergence towards a minimum of the potential energy, with a tolerance of 1% between consecutive meshes.
For this purpose, a mesh refinement was performed in order to achieve a convergence towards a minimum of the potential energy, both for the whole model and for each of its components, with a tolerance of 1% between consecutive meshes.
To this respect a mesh refinement was performed in order to achieve a convergence towards a minimum of the potential energy, both for the whole model and for each of its components, with a tolerance of 1% between consecutive meshes.
(A ) In every trial, the simulated agent can choose between initiating a tolerance response and doing nothing, upon observing the stimulus.
