The phrase "a time of order" is correct and usable in written English.
It can be used to describe a period characterized by stability, organization, or control, often in contrast to chaos or disorder.
Example: "After years of turmoil, the nation finally entered a time of order, allowing for rebuilding and growth."
Alternatives: "an era of stability" or "a period of control".
For many others, however, including the thousands of Indonesians who showed up at special prayer services for Mr. Suharto that culminated Friday, 1,000 days since his death, the move taps into nostalgia for a time of order and stability that contrasts with today's messy democracy.
With J / U = 0.1, this gives a time of order 10 / U in two dimensions and a somewhat shorter time in one dimension.
When a kinked bar with mode frequencies of a few hundred hertz is shaped so that two modes have the desired 2 to 1 frequency relation and is excited by striking it at a node of the higher mode, then the amplitude of that mode rises from zero to a maximum in a time of order 0.1 s and then decays.
In our rescaled units, the correlation functions decay over a time of order 1, corresponding to a time of order 1/ s in real time.
Hence, fixation should occur after a time of order L. By contrast, we find much earlier fixation after a time of order L3/2.
After a time of order N, the entire spectrum has relaxed to the neutral haplotype frequency spectrum as shown in Figure 2B.
The water absorption in hemp occurs in two steps: about half the water enters the material in a time of the order of a minute, while the second half of water slowly penetrates over a time of the order of three days.
Yet Canute's rule was not tyrannical, and his reign was remembered as a time of good order.
The dynamic evolution has been monitored through a time of the order of 100 ps.
We conclude that GRB flares are due to internal shocks and leave still open the question of whether or not the central engine is active for a time of the order of 105 s after the prompt emission.
The system consists in an electrical resistive thin component and an insulation layer and can increase the mold surface temperature of some tenths of a degree Celsius in a time of the order of one second.
