Sentence examples for a thin cutting from inspiring English sources

Using a hobby tool (e.g., Variable Speed Rotary Tool, Dremel, Racine, WI, USA) with a thin cutting blade, the female threaded section around the luer tip of the injection site (Baxter #2 N3399) was removed as shown in Figure 1A.

Tilt the leading edge slightly away from the direction of travel to create a thin cutting edge where the screed board meets the concrete.

The magnetite/chitosan composite was treated with ultra thin cutting to observe the dispersion of magnetite nanoparticles in magnetite/chitosan composite (Fig. 4a).

The SS brigades, wrote historian Christopher Browning, were "only the thin cutting edge of German units that became involved in political and racial mass murder".

Lung specimens were fixed with formalin and embedded into paraffin then sectioned in a thin-slice cutting machine.

In this study, an improved arc-fillet-line triangular valve orifice is designed based on a general line triangular valve orifice according to the relationships between the fluid differential pressure of a thin-walled cutting edge and the fluid flow area and between the correlation coefficient of the theoretical pressure difference and standard sinusoidal signal.

Based on the concept of a sinusoidal signal output, an improved arc-fillet-line triangular valve orifice is designed according to the relationships between the fluid differential pressure of a thin-walled cutting edge and the fluid flow area calculated from the relative rotation angle of the rotor to the stator through the established polar coordinate equations.

It can be a thin linear space cutting next to buildings".

The best versions are forged -- cast, blade to tang, in a mold and tamped to create the slope from the spine to the razor-thin cutting edge -- from high carbon stainless steel, an alloy that holds an edge without rusting.

This is because the cleavage degree is lighter due to the thinner cutting depth, which does not generate serious pits on the machined surface.

If cutting the letters themselves, you can get the two-layer, beveled look by cutting a thin line deeply first and then makes a second pass with a thicker but shallower bit.