This approach consists in using weights based on the propensity score to create a synthetic sample in which the distribution of measured baseline covariates is independent of treatment assignment.
We used IPT as the weights based on the propensity score; we did so to create a synthetic sample, in which the distribution of measured baseline covariates was independent of treatment assignment [31 33].
We used IPT as the weights based on the propensity score; we did so to create a synthetic sample, in which the distribution of measured baseline covariates was independent of treatment assignment [ 31– 31].
According to the statistical analysis of the synthetic sample of Ni and Pb, with 0.94 and 0.99 line slope, the maximum efficiency of removal of Ni and Pb in the concentration of 100 mg/L, and the DO of 4 5 mg/L, at 20 35 °C and retention time of 120 min was 74.5 and 75.1%, respectively.
We began our NMR spectroscopic studies with analysis of the synthetic sample of Fmoc-protected (3 S,5 R -5-chloropiperazate pR -5-chloropiperazatethe R -5-chloropiperazateprepared Informaccording
We carried out 1000 simulations to estimate the K-S test similar to the previous section for synthetic samples of a HTR distribution with α=1.25,γ=1.5 and for 10,000≤N≤100,000, and the simulation results are demonstrated in Fig. 4 b.
No evidence of epimerization at the C5' position was observed.[ 17] The assignment of the relative stereochemistry of 2 was completed by comparison of the reported spectroscopic data[ 2c] for 2 with those obtained for our synthetic samples of 2 a and 2 b.
After the pre-processing step described previously, an edge detection step is performed by means of a multi-layer perceptron (MLP) [22] trained with synthetic samples of edges and non-edges, using the supervised learning backpropagation algorithm, with randomly initialized weights and 10 trials for each trained network.
It involved creating synthetic samples of ore using pyrite grains suspended at known locations within a matrix made of quartz and poly methyl methacrylate).
The training set was made up exclusively of synthetic samples of 3×3 pixels size.
Unmetalized and electrically shorted device configurations were used to analyze synthetic samples of liquid detergents of different concentrations.
