The limiting concentration of each diluent was measured by systematically varying the composition and ignition energy and finding the limiting condition through successive experiment trials.
Each successive experiment had 0.3 g more K2S2O8.
Preliminary analysis showed that neither SDAs nor ARMs changed significantly across the successive experiment sessions (F 2,16) = 1.82 and 0.49, respectively).
The average supersaturation field is predicted for precipitations in the case of partially premixed feed streams by a simple mixing model from a couple of successive experiments with the same inert tracer by Planar Laser Induced Fluorescence and using a single camera.
In addition, as CO2 was substituted for O2 in successive experiments, a nonlinear relationship, as a function of the gas composition, was observed for ignition delay time and burn time.
We design a new core-holder to permit successive experiments without plug replacement, which ensures the consistency of the measurement environment.
This review focuses on Variable Angle Spinning (VAS), Switched Angle Spinning (SAS), and Dynamic Angle Spinning (DAS), all of which involve spinning at two or more different angles sequentially, either in successive experiments or during a multidimensional experiment.
Each subject participated in all experiments in a pseudorandom sequence such that no two successive experiments would involve the same digit.
Successive experiments were acquired over a time period of 50 (scPCNA) or 3 days (hPCNA) at various intervals and with a larger number of scans in the later experiments to increase the signal-to-noise ratio (between 32 and 256).
Independently of the gas used and in order to improve reproducibility of the experiments, as well as to standardize any possible effect on the loss of volatile compounds, successive experiments were performed using a programmed on/off pattern for the gas valve, mimicking the pattern obtained in that preliminary experiment (Table S1 in the Supplementary Material).
The treatment of a set of diluted Cr VI) solutions (0.8 mM) in successive experiments with the reused photocatalyst was more efficient for Cr VI) removal in the presence of EDTA (2 mM, 700 s total irradiation time) than the use of a more concentrated sample (Cr VI) , EDTA ) with the same photocatalyst submitted to a longer irradiation (900 s), indicating a good strategy for application.
