Sentence examples for a step height of from inspiring English sources

A calibration grating with a step height of 25 nm was used as the sample.

The standard deviation of 10 times measurement results of a step height of 1 mm configurated with two gauge blocks is 0.5 nm.

The (111)f and (552)f facets showed a single set of ledges with a step height of ∼1.1 nm and an associated displacement vector along ∼[335]f.

Some clear nucleation centres on the melt-crystallized surface and typical lamellar morphologies with a step height of 11.7 ± 0.5 nm were observed.

These lipid bilayers showed a step height of ∼5.5 nm (data not shown), consistent with dimensions from the literature on DOPC bilayer thickness.

With this setup, it was possible to measure IR spectra in samples reliably and rapidly along the whole cross-section with a step height of 100 μm.

Subjects were instructed to step down from a platform with a standard step height of 170 mm.

Five approximately equidistant steps can be observed in a range of 7.5 nm which is equivalent with a step height or a layer thickness of 1.5 nm. Figure 7 Nc-AFM image of [Mn III 6 Cr III ](C 3 H 5 O 3 ) 3 prepared on HOPG as a monolayer ( a ).

The terraces reveal an average step height of 1.4 ± 0.1 nm as expected for upright standing molecules.

STM height measurement was calibrated by setting the step height of a monatomic step on clean Cu(111) equal to 0.208 nm.

This exposure included a 5-minute step test (step height of 25 cm, 1 complete step every 2 seconds) at 95 minutes.