For each line segment, GIFT selects the most relevant FOVs where the relevance are measured as a linear combination of the distance from the FOV's camera location to the route and the orientation difference between the FOV's orientation and the specified orientation.
The guidance law consists of two terms: one is Trajectory-Shaping Guidance (TSG) used for steering the vehicle to the target from the specified orientation; the other is Final-Speed-Control Scheme (FSCS) used for controlling the vehicle to perform lateral maneuver to adjust the final speed.
In this article, we further extend the Queue-formation structure (or Q-structure) in 3D spaces with additional features including: (i) specifying orientation information, (ii) a mechanism for forming sub-formations before the convergence into the final formation, and (iii) adapting the communication structure when communications are limited.
The mitotic spindle, a dynamic bipolar structure composed primarily of microtubules (MTs) and organizing proteins (Walczak and Heald, 2008), must adjust to cell size to segregate chromosomes the proper distance and signal to the cell cortex to specify orientation of the cleavage furrow (Levy and Heald, 2012).
Regardless of the type of the intended analysis, a kinematic model of the machine tool has to be developed in order to determine the translational and rotational joint movements required to achieve a specified position and orientation of the cutting tool relative to the workpiece.
After starting a new test, a camera preview will appear in the Google Glass viewing window with a vertical test outline overlay to assist the user in placing or holding the RDT at a specified distance and orientation.
He formulated a planar pose problem and found a pushing plan to move a polygonal object to a specified goal position and orientation.
This paper describes the design of a guidance law used for guiding a hypersonic gliding vehicle against a ground target from a near-vertical orientation with a specified final speed and a near-zero final load factor.
The DEM simulations are used to collect tablet orientations when the tablets enter a specified spray zone.
If Place Note Flat to Screen is checked, or once you have specified the orientation as above, place the note just as you would place it in a drawing.
