Sentence examples for a slit height of from inspiring English sources

They were perfused in a small parallel-plate perfusion chamber with a slit height of 0.1 mm and a slit width of 2 mm corresponding with flow rates of 15  μl min−1 (shear rate 10 s).

The microchamber has a slit height of 0.2 mm and a width of 2 mm and contains a plug on which a coverslip (18 mm × 18 mm) with confluent HUVECs was mounted.

With the slit beam at a 45◦ angle, the slit height and width are adjusted to approximate the overall brightness of the corneal image and anterior subcapsular zone to nuclear color/opalescence standard N1; 0◦ brightness is allowed to visualize all the lens opacities without causing discomfort to the patient.

It was shown that reducing the slit height and the number of feeding channels had a significant effect on droplet size distribution, leading to a smaller mean droplet size.

The examination of the selected polymers with different slits gave essentially the same results at each slit height, verifying the absence of wall slip.

This work addresses this issue by characterizing experimentally (using the micro-PIV technique) and numerically (using CFD) steady-state Newtonian (water and water/glycerine solutions) fluid flows and non-Newtonian (water/glycerine/xanthan) blood analogue flows, in a slit with a height of 1.3 mm and a width of 30 mm.

In this study, we show by performing both molecular dynamics (MD) and Langevin dynamics (LD) simulations that the lateral diffusion of a single flexible polymer in a good solvent in a slit should be determined by a complicated interplay among the slit height (H), solvent types and slit wall roughness.

For that, five different values of the slit height, 0.7, 1.0, 1.5, 1.5 and 2.0 mm, were used together with five differently finished surfaces for the channel bottom wall, possessing average roughness values of 31.4, 11.4, 4.1, 1.3 and below 1 μm, which is the sensor detection limit of the contact profilometer used for the measurements.

Signal-to-noise ratio (S/N ratio) of the monochromator does not vary with slit width as light source is continuum, but S/N ratio varies inversely with slit height.

The modular design eases the die cleaning, and measurements with variable slit heights enable the detection of possible wall slip.

Chromatograms of the samples were scanned at 254 nm in the single-wavelength, single-beam mode with the TLC Scanning Densitometer with a slit setting of 7 mm length and 1 mm height.