The phrase "a selected threshold for" is correct and usable in written English.
It can be used when discussing a specific limit or criterion that has been chosen for a particular purpose or analysis.
Example: "In our study, we established a selected threshold for determining the significance of the results."
Alternatives: "a chosen limit for" or "a defined threshold for".
In (3), ρ is a selected threshold for reducing the noisy effect and should be proportional to I(p). Figure 3 shows how trinary census works well under noise environments.
Figure 6 shows summary receiver operating characteristics curves for commonly reported cut-off values and a curve of all studies at a selected threshold for each study.
For a selected threshold for miRNA-mRNA correlations, we estimated the total number of miRNA-mRNA pairs with correlations better than or equal to the threshold found by chance using permutation-based tests.
Top significant GO categories, biological functions and different canonical pathways were analyzed for miRNA specific targets as well as for all screened targets based on significant over-representation of genes using a selected threshold for p-values ≤ 0.05 of hypergeometric distribution [ 94].
Finally, SNPs with poor clustering were also excluded after visualisation with Evoker (briefly, associated SNPs at a selected threshold were selected for comparison of the two intensity channels against each other to manually check the proper assignment of the genotype-calling algorithm) [ 13].
The length of all segments must then satisfy the following relationship to be detectable: (3) where c i is the average expected median coverage on the region of interest, d is the difference in coverage from the neighboring segment and α is a selected threshold factor (3.890592 for 0.01%).
Based on the spectral similarity and retention-time shift corrections, SpectConnect filtered out all peaks that were not detected or below a selected threshold signal, generating three matrices (for relative amount, amount and integrated signals) which were later used for multivariate statistics.
The selected threshold for a PSSM m and the corresponding sm are used to integrate m into the naïve Bayes classifier (1).
Thus, we would expect to see no heptamers with MCS values higher than the selected threshold for each region.
We selected thresholds for distinguishing land systems based on an expert survey.
Raw CT-values were calculated using the SDS software (Applied Biosystems), applying manually selected thresholds for each miRNA.
