The phrase "a screw through" is correct and usable in written English.
It can be used when describing the action of inserting a screw through an object or material, typically in a construction or assembly context.
Example: "To secure the two pieces of wood together, insert a screw through the pre-drilled hole."
Alternatives: "a screw inserted through" or "a screw passing through".
In this case, we should have considered the distance between the two fractures to be a prognostic factor, and the possibility of using a low-profile plate that can be modeled in the proximal part to allow introduction of a screw through the proximal hole of the plate into the femoral neck if the two fractures are too close together.
The latter arrangement allows the resonators to be tuned by inserting a screw through the wall of the waveguide into the centre hole of the resonator.
Though skilled technically, Lane recognized the difficulty in placing a screw through both cortices, "To reduce the difficulty of finding the drill hole in the distal compact layer of bone, which is frequently of no avail when the fragment is comminuted, I employ screws of a length only sufficient to engage the proximal compact tissue…" [ 5].
Insert a screw through each corner of the case fan.
Place a screw through each hole in your flange.
Insert a screw through the hole from inside the tubing.
We describe a technique using an interference screw through a single incision.
The displaced fragment was reduced by elevators, and fixed with a bicortical screw through a minimised preauricular incision under general anaesthesia.
Hadrick and I squeezed into the heated cab of a huge swivel-hipped tractor hooked up to a feed mixer: basically, a dump truck with a giant screw through the middle to blend ingredients.
And navigation through the viscous seas would require an innovative form of propulsion, perhaps in the form of a screw drilling through the liquid.
In all 12 cases of Weber type C fracture and in 1 case of type B, the tibiofibular joint was diastased and we performed a trans-syndesmotic fixation with a screw going through one of the holes of the plate, in order to obtain an anatomical reduction of the diastasis and to further stabilize the osteosynthesis.
