The phrase "a satisfactory process" is correct and usable in written English.
It can be used when discussing a method or procedure that meets the required standards or expectations.
Example: "After reviewing the project, we concluded that the team had implemented a satisfactory process for quality assurance."
Alternatives: "an acceptable procedure" or "a suitable method".
The study also found that, according to corporations, ADR is "a more satisfactory process" than litigation when it comes to resolving disputes.
The results clearly indicate a less satisfactory process in the absence of salivary agglutinins, as well as significantly less sufficiency in the mutant strains compared to the parental strain [ 22, 23].
The experimental results show that the proposed method has sufficient capability to generate satisfactory process plans that include a comparable plan as designed by an experienced engineer in a shorter time.
Being able to establish a good relationship with their doctors, or even friendship, is perceived as an important element within a satisfactory treatment process [ 34].
The resulting gate and vent locations lead to satisfactory process performance as indicated by the optimal process performance index.
Crystallization of a potent oncology drug candidate under development at GlaxoSmithKline proved to be challenging in terms of obtaining acceptable yield, consistent and desirable Active Pharmaceutical Ingredient APII) powder properties, with satisfactory process robustness and scalability.
Based on these results it is found that the proposed design technique can drastically simplify the design procedure and that the designed fuzzy logic controller results in satisfactory process response.
The successful implementation of the pilot CRC screening with satisfactory process measures indicate the feasibility of scaling-up organised CRC screening through existing health services in Thailand.
Consequently, all BaTiO3 thin films that were less than 0.5-μm thick showed short-circuit characteristics owing to high leakage currents, while the BaTiO3 thin films that were 0.5- to 1-μm thick had only partial dielectric properties, which was an obstacle in achieving a satisfactory thin film process using the AD process [11 13].
Instead of aspiring to a perfectly parameterized model, the goal of this design tool is to use early model parameter estimates to find interesting experimental spaces, and to refine the model parameter estimates with each new experiment until a satisfactory set of process parameters is found.
