Sentence examples for a sampling length from inspiring English sources

Ra (arithmetic average of the deviation from the mean line over a sampling length) = 55.6 (51.1–63.5) μm, Rz (average difference in height between the 5 highest peaks and the 5 lowest valleys) = 267 (238–299) μm, Rq (root mean square value of the profile departure ) = 67 (61 76) μm, and Rmax (maximum peak-to-valley height) = 267 (238–299) μm.

Measurements of right and left thigh composition are performed using the slices that start at the location 25 mm above and the end 25 mm below this point, providing a sampling length of 50 mm along the long axis of the femur (e.g. head to foot).

Here, we use an SNR set to 40 dB, and a sample length N = 64 with M = 8 array elements.

The absolute accuracy of Vp determination, with respect to intact rock (Vp = 5500 m/s), at a sample length of 70 mm is of 0.8 1.2%.

T. H} , whereV = volume of water(Q) that flows through the sample of cross sectional area (A) in time T and H is the hydraulic head difference imposed across a sample length (L).

Figure 4(a) shows that the proposed method performs better than the ML algorithm in estimating the frequency, because the proposed algorithm adjusts the sampling position to, whereas the ML algorithm has a sample length of 56 for the estimation.

Following BS EN ISO 2062 1995, with a sample length of 50 cm, the cross head moving speed has been adjusted to give a yarn failure time of 20 ± 3 seconds.

Amburgey et al. (1993) study of the Finish newspaper industry represents a clear outlier, with a sample length of 192 years, ranging from 1771 to 1963 and representing 1011 firms.

In order to form the intended steel group 301, the forming tensile die was designed and built based on the critical section and a sample length of 200 mm.

If the values for the STPT are directly derived from the measured state sequence (assuming a sample length of e.g. Δ d = 1m), the dynamic Markov model enables an exact reproduction of the state probabilities as well as an exact re-modelling of the measured SDPDF.

In the final experiment, the RMSE as a function of the difference between the DOAs of two harmonic sources Δθ = |θ1 - θ2| is analyzed for an SNR set to 40 dB and a sample length of N = 64 with M = 8 array elements.