Sentence examples for a result of normalizing from inspiring English sources

As an example, if we were to look at the top right barchart, which corresponds to the 100% AR and 0% NC dye spot location, we see that the absolute error for LASSO and SPLASSO for AR the CAF is 0% (a result of normalizing against the abundance estimate at this location) and is approximately 10% for the SPLASSO and 40% for the LASSO for the NC CAF.

Table 7 is the result of normalizing the local betweenness measure by the global value.

The results of normalizing the impact categories for the European level (Fig. 5) show that "Land use" is the most significant impact category with 0.0759 European equivalents followed by "Respiratory inorganics" and "Fossil fuels" with 0.013 and 0.0086, respectively.

The results of normalizing the damage categories (Fig. 6) show that "Ecosystem quality" is the most representative damage category, corresponding to 0.077 European equivalents, followed by "Human health" and "Resources" with 0.015 and 0.0089, respectively.

For example, relatively high values of any of the 3 biochemical parameters may reflect the general health of a patient, which may not change as a result of treatment geared to normalizing a single abnormality.

Previous studies in long-term care (LTC) have demonstrated that warfarin management is suboptimal with preventable adverse events often occurring as a result of poor International Normalized Ratio (INR) control.

To minimize quantitative differences among fibers due to heterogeneity in the analyzed fiber segment as a result of the isolation procedure, we normalized the entire proteome of each single fiber by the intensity of skeletal alpha actin (Acta1).

> As a result, we normalize the treelet distributions of each individual network, for each value of k as follows.

Finally, our results highlight the importance of normalizing EST levels when estimating the frequency of alternative splicing.

Again, the spectrum is calculated by FFT (the DC component has been removed) and the FFT result is normalized to a range of 0 1 for the ease of comparison.

This result was normalized to the breaking strength of the fibers and compared with Kevlar.