Sentence examples for a reinforcement layer from inspiring English sources

The results show that there exists an optimum design of a reinforcement layer such that both the magnitude of stress concentration and the interfacial stresses could be fairly reduced.

Based on the technique of conformal mapping and the method of analytical continuation in conjunction with the alternating technique, the general expressions of the displacement and stresses in a reinforcement layer and the matrix are derived explicitly in a series form.

The filler rod adds a reinforcement layer for your weld.

The effect of introducing a geogrid reinforcement layer above the pipe on the distribution of contact pressure is also examined.

In this paper, a new strengthening technique for reinforced concrete (RC) beams is proposed by combining Basalt fiber Reinforced Polymer (BFRP) grid and Engineered Cementitious Composites (ECC) as a composite reinforcement layer (CRL).

A geosynthetic reinforcement layer over the geomembrane liner is shown to reduce the maximum geomembrane liner strains, but the strain level of the geosynthetic reinforcement itself may become an engineering concern on steeper slopes (i.e., greater than 3H 1V) for cases and conditions examined in this paper.

The maximum tensile loads of all reinforcement layers at the wall failure predicted using FE analysis and LE method assuming uniform distribution of reinforced tensile loads were comparable.

The LE analyses show that minimum reinforcement length of the upper tier (L1,min = 0.7H1), according to the compound design in FHWA design guidelines, is insufficient, such that failure surfaces do not pass through all reinforcement layers in the upper tier.

This tension map is directly constrained by a pullout capacity envelope at both the rear and front of each reinforcement layer, providing a unified, LE-based approach towards assessing an optimal selection of mutually dependent strength and layout of the reinforcement.

The reinforcing element REINF265 which is based on smeared reinforcement layer is used to reinforce the SHELL181 element.

The smeared reinforcement layer behaves as a unidirectional (in the specified direction) material.