Groundwater mounded immediately upgradient of the PRB, which resulted partly due to a reduction in the width of the alluvial aquifer because of the impermeable slurry walls, and possibly due to a zone of decreased permeability caused by steel sheet pile installation during PRB construction.
McKeown et al. [15] found a reduction in crown width in both buccolingual and mesiodistal dimensions in cases with oligodontia.
Increased time of etching leads to a reduction in the width of groove (with significant "over-etching" decreasing groove height), and the form of section is changed from trapezoid to triangular.
However, presence of a higher MF of 80 mT during the fabrication process leads to a reduction in the width of the large square-shaped pores (approximately 1.2 μm) close to the anode location while the dimension of the pores reduces close to the cathodic region (750 nm), as shown in Figure 4g, h, respectively.
When Gro overexpression is driven in just the dorsal half of the wing pouch, the result is a reduction in the width of the dorsal half of the vgQ expression domain (Fig. 6A, compare top and middle rows).
The same overall effects on shape were seen following 4 and 5 days of immobilisation except that a reduction in the width of condyles in the ventral aspect became apparent with extended treatment (Table 2, highlighted).
Data is described as the migration distance attained, measured by a reduction in the width of the initial scratch.
Notably, cells in the cortex and stele were smaller but more isodiametric in Spcdc25 compared with wild type, caused by a reduction in cell width but not cell length.
Test results also showed a significant reduction in width, and total area of plastic shrinkage cracks of slabs reinforced with an increased amount of RP fibers compared to control slabs without fibers.
