Sentence examples for a reduction in the width of from inspiring English sources

Increased time of etching leads to a reduction in the width of groove (with significant "over-etching" decreasing groove height), and the form of section is changed from trapezoid to triangular.

However, presence of a higher MF of 80 mT during the fabrication process leads to a reduction in the width of the large square-shaped pores (approximately 1.2 μm) close to the anode location while the dimension of the pores reduces close to the cathodic region (750 nm), as shown in Figure 4g, h, respectively.

Groundwater mounded immediately upgradient of the PRB, which resulted partly due to a reduction in the width of the alluvial aquifer because of the impermeable slurry walls, and possibly due to a zone of decreased permeability caused by steel sheet pile installation during PRB construction.

When Gro overexpression is driven in just the dorsal half of the wing pouch, the result is a reduction in the width of the dorsal half of the vgQ expression domain (Fig. 6A, compare top and middle rows).

The same overall effects on shape were seen following 4 and 5 days of immobilisation except that a reduction in the width of condyles in the ventral aspect became apparent with extended treatment (Table 2, highlighted).

Data is described as the migration distance attained, measured by a reduction in the width of the initial scratch.

An increase in the intensity and a significant reduction in the width of the semiheight of the anatase peak (101) can be observed.

Immobilisation caused a significant reduction in the width of the proximal epiphysis of the tibiotarsus and fibula (Table 2).

We also measured a 14% reduction in the width of the neural plate at the mesencephalic level of 2 4ss (embryosembryos (Fig. S2A).

Therefore, it is clear that an increase or reduction in the width of each equal-width interval could significantly affect the upper bound of such deviation.

The activated TIG ATIGG) welding process mainly focuses on increasing the depth of penetration and the reduction in the width of weld bead has not been paid much attention.