Sentence examples for a reduction factor based on from inspiring English sources

As it is difficult to capture the effects of all applicable factors, some of which are intricately interconnected, it appears more appealing to seek a reduction factor based on experimental data.

46 Data on the incidence of fractures in Spain were taken from either the published literature (in the case of hip fractures) 47 or derived from Swedish data after applying a reduction factor based on the reported incidence from both countries (Spain compared with Sweden).

In this study, analytical formulations of the damping reduction factor based on power spectral density functions are derived and compared with the main formulas available in the scientific literature.

A new technique is presented that uses two horizontal and vertical FE models to consider the concrete stiffness reduction of NPP buildings subjected to orthogonal ground motion excitations, in which appropriate stiffness reduction factors, based on the input motion orientation, are applied.

The proposed approach consists of determining a reduction factor, (R_{v}) based on extensive test data with different variables that can be applied to correct the theoretical shear capacity of a corroded beam, calculated on the basis of reduced cross-sectional area, (A_{v}^).

Fig. 5. (a) Lags with maximum correlation coefficients between the observation and the simulation with (green)/without (red) the SAL effect, (b) optimal SAL factor based on the maximum RMS reduction of the observation, and (c) RMS reduction of the observation by simulated results.

Hence, a reduction factor was proposed for older pavements based on cumulative traffic volume for the above correlation to predict the skid resistance of older pavements.

The design shear equations based on a reduction factor α to account for reduced TFA were proposed by Pham and Hancock in cases of partly bolted connections with lateral flange restraints.

Weld strength reduction factors (WSRFs) based on the weld metal, and weld joint have been evaluated, and compared with the codes.

Create a reduction plan based on the suggestions above and pilot it for a week.

Based on the test results, a reduction factor is proposed to modify the EC3 equations to produce reasonable conservative prediction of the RQT joint design plastic resistance.