The phrase "a process is possible" is correct and usable in written English.
It can be used to indicate that a certain process can be achieved or is feasible under specific conditions.
Example: "After reviewing the requirements, we concluded that a process is possible to streamline our operations."
Alternatives: "a process can be achieved" or "a process is feasible".
Our comparison shows that due to the significant recycle of enzyme within the process (quantified using the process model), a significant reduction in the quantity of enzyme necessary over a batch process is possible even if some unaccounted activity losses due to adsorption or inactivation were to occur.
But the thing is, now that we as consumers know that a seamless process is possible, our expectations have changed.
The second dynamic theorem we will make use of says that if a dynamic process is possible, then the process resulting from inverting the direction in which all the bodies involved in it move is also possible.
Many insurance physicians score highly in terms of following rules during the assessment, so that a fair process is possible, while only few insurance physicians indicate that their work style is to look for compromises in the event of a difference of opinion with the client.
The value of the UN's extensive consultation process to create the High-Level Panel report with 12 "illustrative" goals, does not simply lie in the capacity to develop a first draft of the goals themselves, but in demonstrating that an inclusive process is possible, and that an apparent consensus can be achieved.
Therefore, the purpose of the present study was to develop an instrument that can be integrated in the Dutch police system, so that an automatic screening process is possible within a limited time frame and with minimal cost.
The research illustrates that mapping a highly multivariate process is possible.
If, in addition, the reservoir is fractured with low permeability matrix blocks, water flooding of the reservoir is not recommended unless a wettability alteration process is possible.
At lower dUsingycles (below 15% duty cycle), not enough nitrogen was available to allow the formation of expulsed austenite, whilowhighenergyy cycles led to a reduced layer thionness caused by himplantationring induced by the increased ion bombardment itself.
It shows that a pulsed laser forming process is possible that delivers reproducible patterns, which depend on the irradiation pattern, but do not directly reproduce the mask or irradiation pattern.
