Sentence examples for a previously published experiment from inspiring English sources

Thus, we turned to multiple-electrode data from a previously published experiment with a unique design8, 9. Monkeys determined whether a test sequence of two objects matched a sample sequence presented seconds earlier.

Video recordings taken at the time of data collection for a previously published experiment [ 25] were used for analysis.

This study is part of a previously published experiment in which end-to-side ileorectal anastomosis, constructed with 4-0 sutureuture, was performed in rats, as described elsewhere [ 13].

Finally, we performed a combined analysis of Experiment 1a, Experiment 2, and a previously published experiment (Experiment 6 in van der Hoort et al., 2011) to isolate the effects of body size, body ownership, body visibility, and fixation across different experiments.

However, it is unclear if this phenomenon is a common feature in other organisms, as all previously published experiments studied tractable subtelomeric evolution in haploid organisms (Bopp et al. 2013).

In the light of the above findings, we also re-examined the growth data from our previously published experiment on male rats ([ 18] and see also Additional file 4: Table S4 for raw data).

The tuning of the model's parameters has been carried out to match a set of data described in previously published experiments (Pascucci et al. 2007).

The prediction about a short experience of stressing condition is confirmed by previously published experiments (Imperato et al. 1992 , 1993, whereas the new experiment here reported validates the prediction concerning a long-lasting experience of the same stressor.

As shown in Figure 2, we observed that approximately 79% of the embryos were dead or exhibited a highly deformed "monster" phenotype, consistent with previously published experiments performed with these ZFNs [27].

As such, our simulation is a test setup that corresponds more closely to reality than previously published experiments.

Microarray data from these and previously published experiments [ 5, 6] were adjusted through a printtip lowess correction followed by quantile cross-normalization across all arrays using the Limma package in Bioconductor [ 50].