The phrase "a partition plate" is correct and usable in written English.
It can be used when referring to a specific type of plate that serves to divide or separate spaces, often in contexts like engineering, architecture, or manufacturing.
Example: "The engineer specified that a partition plate should be installed to enhance the structural integrity of the building."
Alternatives: "a dividing plate" or "a separator plate."
The mandible was placed in the test pool, and the inferior alveolar nerve was passed through a hole at the center of the partition plate and placed in the recording chamber (oil pool), where it was fixed to the wall of the chamber with cotton thread.
Both CFD simulations and experiments show that the (superficial) liquid exchange velocity, Uex, at the partition plate is independent of column diameter; the exchange velocity Uex is however found to be a strong function of the open area of the partition plates.
High distillate productivity resulted, due to high convective heat transfer by humid basin air from high temperature float wick surface to first partition plate, feed water pre-heating from waste heat recovery, reduced basin bottom and side losses, and high night distillate productivity as a result of additional heat stored in multiple floating wicks.
The hole at the center of the partition plate was capped with Vaseline.
As a consequence, in the case where the composite adsorbent is used, the insertion of partition plates into a conformable ANG vessel does not significantly improve heat conductivity.
The height of the gas cap forming underneath partition plates decreases significantly with increasing column diameter; this is a desirable result from the point of view of scale up.
Charge/discharge cycles of methane on a cylindrical tank and a conformable tank were assessed for evaluation of the structure of tank and the partition plates, the composition of adsorbent, and the dynamic behaviors of storage system.
This work is focused on the transient thermal simulation of simplified counterflow recuperator partition plates.
Results reveal that the number of partition plates has important influence on the bending resistance of the structure and more partition plates do not necessarily lead to high energy absorption efficiency.
Partition plates are introduced in longitudinal direction and cross-section of square tubes to form multi-cell structures.
