The phrase "a low rotation" is correct and usable in written English.
It can be used in contexts related to mechanics, engineering, or any field where rotation speed is relevant, indicating a slower than normal speed of rotation.
Example: "The engine operates efficiently at a low rotation, which helps to conserve fuel."
Alternatives: "a slow rotation" or "a reduced rotation".
Consequently, the low voltage output produced by the RF-EMGs can hardly be stored inside a capacitor at a low rotation speed (< 40 rpm).
For a low rotation speed (600 rpm), the tool shape does not significantly affect the microstructures and mechanical properties of the joints.
The minimum thermal conductivity at a low rotation rate is 0.8 W/(m K), well below that of conventionally deposited coatings.
For a given exposure time, a high rotation rate will increase the recorded fraction of each reflection on an individual frame, but a low rotation rate will ensure that even weak, high-resolution reflections accumulate enough counts on the detector before leaving their diffracting condition.
To make the SiNW and polymer composite together efficiently, we deposited polymer onto SiNWs by spin coating at a relative low rotation speed.
We found that at a relatively low rotation speed of 3.5 rpm dexmedetomidine induced LORR in C57BL/6 mice with an ED50 of 125 ± 16 μg/kg (Fig. 1B; see Data S1, videos S1 and S2).
The LOW rotation had the lowest weed density.
In this paper, we answer a question raised by Lev Pitaevskii and prove that the ground state of the Gross Pitaevskii energy describing a Bose Einstein condensate in a rotationally symmetric trap at low rotation does not have vortices in the low density region.
In contrast to the agitated tank used in this work, a rotating drum is operated at low rotation speeds and relies on the mixing obtained when material falls to the bottom of the drum.
At low rotation rates a disagreement may occur between experiments and predicted data.
For the 60 ppi RVC RCE, the jet electrolyte flow (3.5 cm3 s−1) enhanced the mass transport rates by a factor of 1.46 at low rotation speeds; this factor was reduced to 1.08 at high rotation speeds.
