The phrase "a low injection" is correct and usable in written English.
It can be used in contexts related to medicine, technology, or any field where the term "injection" is relevant, indicating a small or minimal amount being injected.
Example: "The doctor recommended a low injection of the medication to minimize side effects."
Alternatives: "a small dose" or "a minimal injection".
The overflushing can cause a large proppant-free region near the wellbore, while the tail-in process at a low injection rate can fill the injected proppant in the proppant-free region.
The gel is easy to inject through small diameter needles and requires a low injection pressure, both of which are important considerations for the delicate tear trough area.
Under a low injection pressure drop of 0.1 MPa, the maximum deviations of the discharge coefficient and spray cone angle under 5 ambient pressure conditions were 22.6% and 31.2%, respectively.
Therefore, a composite process of overflushing and tail-in with large proppant particles at a low injection rate can improve proppant distribution in the fracture, which will greatly increase the productivity of fractured wells.
We present results from two experiments designed to represent different injection scenarios: (A) low injection rate and strong capillary barrier and (B) high injection rate and weaker capillary barrier.
The PL spectra of CdTe0.5Se0.5 cores red-shifted with time under a low injection speed.
They observed an increase in permeability initially then a decrease for low injection rate cases.
To ensure low injection barriers, a thin film of 2- 3- adamantan-1-yl propyl -3,5,6-trifluorotetracyanoquinodimethane (F3TCNQ-Adl) was cast from solution onto the ITO surface.
CERN accelerator physicists next aim to increase the intensity of the beams, perhaps ramp up their energy just a bit from its current low "injection" level, and steer them into each other to start making collisions in earnest, Gillies says.
An IH-linac which has features of high acceleration efficiency, a high energy gain and a low energy injection has been studied.
On the other hand, the phenomenon of sequenced nitrification and denitrification could be observed when a low air injection rate (=0.5 L/min).
