The phrase "a low cycle" is correct and usable in written English.
It can be used in contexts related to cycles, such as mechanical cycles, economic cycles, or any situation where a low frequency or intensity cycle is being described.
Example: "The engine operates efficiently during a low cycle, minimizing wear and tear on its components."
Alternatives: "a minor cycle" or "a reduced cycle".
A low "cycle count" implies a lot of pathogen.
Thermomechanical fatigue (TMF) is a low cycle fatigue process in which material life is correlated to the mechanical strain amplitude.
Available fatigue test data are utilized to generate a low cycle fatigue damage model for bimodal grains size Al 5083 and obtain the damage model constants for varied levels of coarse grains.
Fatigue tests of standardised uniform-gauge test specimens with duplex coating (plasma nitrided and hard PVD coating) were carried out in a low cycle regime at stress ratio R ≈ 0.05 at elevated temperatures of 150 °C and 500 °C.
To develop a fatigue design curve of cast stainless steel CF8M that has been used in piping material of nuclear power plants, a low cycle fatigue tests were conducted in the environment of a pressurized water reactor at 15 MPa and 315 °C.
Incorporating a low cycle PCR step minimized the latter issue but GBS variant filtering required additional metrics, such as linkage disequilibrium, heterozygosity, and Hardy-Weinberg Equilibrium (HWE).
Then, a low-cycle fatigue damage model is employed to determine the maximum cyclic deformations that such piles can sustain.
This paper presents the results of a low-cycle fatigue test on a galvanised steel lighting column.
Uniaxial material models and a low-cycle fatigue model were used to characterize the cyclic stress strain response and low-cycle fatigue life of the specimens.
Under these conditions, an Fe 15Mn 10Cr 8Ni 4Si alloy with a low-cycle fatigue life of approximately 8000 cycles for a total strain range of 2.0% could be developed.
Modeling methods and a low-cycle fatigue failure criterion are validated using experimental results, and then 23 models with varying multi-axial stress states are analyzed under various ranges of cyclic rotation.
