Sentence examples for a large mode from inspiring English sources

The size distributions of the non-volatile particles for all ships contained a large mode at ∼10 nm.

A large mode area multicore photonic crystal fiber with a flattened fundamental mode is proposed in this paper.

Thus, the proposed octagonal core octagonal quasi-periodic clad LCF exhibits a large mode area of 1161 μm2, a low BL of 0.04 dB/m for the LP01 mode and a high differential loss ratio of 1624 between LP11 and LP01 modes at a critical bending radius of 15 cm with an air-filling ratio of 0.4.

Ytterbium doped LMA fibers also have the advantages of a larger mode field diameter (MFD) which negates the impacts of nonlinear effects such as stimulated Brillion scattering (SBS) and stimulated Raman scattering (SRS), which limit the achievement of higher power levels, and provides a distinct advantage over single mode Yb doped fibers.

The majority of the observed particles were formed during the actual spraying process, and were in two main size modes; a smaller mode located around 60 nm and a larger mode at 750 nm.

Nevertheless, a lower stretching efficiency of the monolithic stretcher was shown; detailed studies attributed it to a larger beam waist size at the waveguide output caused by a larger mode field diameter of the waveguide.

Sudmeyer, T. et al. Nonlinear femtosecond pulse compression at high average power levels by use of a large-mode-area holey fiber.

The laser output is coupled into a large-mode-area photonic crystal fibre (PCF) of 26 μm mode field diameter and 8 cm length for spectral broadening via self-phase modulation.

Wavelength tunable high energy ultrashort laser pulses are generated from a large-mode-area photonic crystal fiber in anomalous dispersion (AD) regime.

Numerical investigation on the design of a large-mode-area (LMA) single-mode photonic crystal fiber (PCF) as the sensing fiber for Raman distributed temperature sensor (DTS) is presented.

It is shown in our simulation that the troublesome SBS can be effectively suppressed by broadening the signal linewidth to a critical value of 0.07 nm in our calculation, and the effect of SRS can be suppressed using a large-mode-area fiber with proper length.