The phrase "a joint plane" is correct and usable in written English.
It can be used in contexts related to geometry, aviation, or collaborative efforts where two or more entities share a common level or surface.
Example: "The engineers designed a joint plane to ensure that both structures would align perfectly during construction."
Alternatives: "shared plane" or "common plane".
Failure occurred along a major joint plane paralleling the slope with a dip of 44°, when a major base level lowering event in the Salt River system would have undermined the base of the failed slope, and probably during a period of more moisture than normally available in the present-day arid climate.
This paper describes an experimental study on the structural behavior of the joint plane between a RC (reinforced concrete) wall and a SC (steel plate concrete) wall under out-of-plane flexural loads and in-plane shear loads.
The Osprey, a tilt-rotor aircraft that takes off and lands like a helicopter but flies like a plane, was conceived two decades ago, at the height of the cold war, as a joint Army-Marine Corplaneane.
In our study, we used the foveal soft tissue as an indication for locating the original joint plane.
Considering the above requirements it would be difficult to address all the above application areas with a universal methodology unless we could model the audio signal as accurately as possible in a joint TF plane and then adaptively process the model parameters depending upon the application.
A lateral curvature of the distal tibiotarsus (Fig. 6) would lead to a change in the angle of the intertarsal joint plane and, thus, affect the position of the tarsometatarsus and move the foot to a more medial position.
The angles of the distal tibiotarsal (intertarsal) joint plane have been reported to differ between the ringed teal (a semi-aquatic species) and the quail (a cursorial species), which supports our findings on tibiotarsal bending in the medio-lateral plane [ 33].
The developed software satisfied the fast analysis requirements of joint plane simulation, spatial block modelling, keyblock identification and failure process illustration.
This work is focused on the modeling efficiency of the discrete element methods to represent the behaviour of mine dump masses with the specified joint plane for the limit equilibrium method.
Figure 6 shows differences in the expression observed in control and immobilised embryos on longitudinal sections through the knee joint (plane of section as in Figure 2D).
