Sentence examples for a high pressurization from inspiring English sources

A high pressurization injection device (HPID) useful for micro-volume syringes was built in order to achieve practical, controlled and precise injections of sols, solvents and electrolytes in the capillaries.

Finally, delayed cycling can also occur as a result of increased leaks caused not by an insufficient mask seal but by a high pressurization rate [ 9].

For application in nanothermite-based impact primers, it is important to generate a high pressure peak with a pressurization rate as high as possible to accelerate a thin plastic or metallic foil to a few hundreds of meter per second.

Pressurization by vapor H2 supplies a higher pressure and also a temperature rise, which is significant to consider the selection of pressurant gas.

The company found that the likely cause was frozen oxygen, which burst a high-pressure tank containing helium, which is used for pressurization during the second stage of the rocket's launch.

In the smaller fault zone, marked differences in hydromechanical properties (Young's modulus and permeability) favor fluid accumulation, inducing high pressurization in parts of the damage zone, potentially resulting in small seismic events.

The depth of penetration increased with higher pressurization pressure, duration of pressurization, and earlier stem insertion (lower viscosity), but maintained a similar profile.

The direct effect of a high flow on pressurization is shown by the compensated negative pressure drop during inspiration at the lower pressure level in almost all settings.

The sample of 5 wt.% nitrocellulose showed the best response relative to the physical mixing case, with a 3× higher pressure and pressurization rate.

Moreover, combustion cell tests results show that nAl/a-HI3O8 has the highest pressurization rate and peak pressure and shortest burn time, and since it also has an iodine content of ∼75% as high as I2O5 on a per mass basis, this material may be a very promising candidate in biocidal application.

Contrary to a premise that small CuO pores would result in mixing with Al nanoparticles at a smaller length scale and hence higher pressurization rate, 3DOM CuO with pore size smaller than 240 nm exhibits gradually lower pressurization rate as pore size decreases.