The phrase "a high increase of" is not correct in standard written English.
It is redundant because "high" and "increase" convey similar meanings, and it is better to use one or the other.
Example: "There has been a significant increase in sales this quarter."
Alternatives: "a significant increase in" or "a large rise in".
A high increase of the oxygen evolution overvoltage could also be seen.
Up to 5 phr of JHNPs, a high increase of the viscosity at low frequencies was observed.
A high increase of conductivity was recorded in the treatments resulting from tested diets (T4, T3, and T2) compared to those from the standard diet (T1).
All plots confirm results obtained by CVs as they show a classical capacitive behavior, with a high increase of their imaginary part at low frequencies.
The results have shown that femtocells are a good solution in order to enforce the capacity of a macrocell deployment without a high increase of energy consumption avoiding the introduction of new macroBSs to extend coverage and availability.
By tailoring the pore texture of CDCs as removal of amorphous phase by post air-activation, the anode electrode showed a high increase of capacity under prolonged cycling and under high C-rate conditions such as 0.3 1.0 C-rates.
However, a higher increase of in vitro protein digestibility (IVPD) was produced by dehydration in all legumes from 12%to15%5%.
The subgroup 1 showed a higher increase of OA, at the end of the therapy, which is probably related to the skeletal anchorage, which maintains the lower incisor anteroposterior position and facilitates a forward displacement of the lower jaw.
Cashmere and Celtiberic goats induced different vegetation dynamics, with the latter causing a higher reduction of shrub cover and a higher increase of dead matter and herbaceous plant cover than Cashmere grazing.
Concerning the non-linear analysis, the results are given for various plate aspect ratios and vibration amplitudes, showing a higher increase of the induced bending stress near the clamps at large deflections.
This model, however, did not perfectly fit the experimental results; especially, the increase of the rde rotation speed corresponded to a higher increase of the limiting current than predicted by the model.
