Exact(1)
A high disintegration degree of 62.3% was achieved while the energy consumption of microwave was much lower than previously reported.
Similar(57)
Despite the popularity of orally fast disintegrating tablets (FDTs), their formulation can sometimes be challenging, producing tablets with either poor mechanical properties or high disintegration times.
Using this histomorphometric approach, we observed that there was a high level of disintegration in negative controls (no scaffold or cells) and constructs seeded with cells but without a scaffold, accounting for approximately 100%and75%5%, respectively of the total interface (Fig. 6B).
The increase in viscosity change (lower viscosity) with increasing the power input was due to higher disintegration of asphaltene flocs.
The decrease in viscosity during sonication treatment of bitumen can be attributed to higher disintegration of asphaltene flocs.
Various HC systems were compared in terms of disintegration of WAS, and, among them, the EFM-HC system exhibited the best performance with the highest disintegration efficiency of 47.0 ± 2.0% as well as the destruction of WAS morphological characteristics.
H2O2-pretreated CS has shown higher synthesis of MnP and LiP and higher disintegration of lignin, but it inhibits cellulase synthesis and cellulose degradation [ 16].
The state coroner, Michael Barnes, found the six deaths were "part of a gross, mass murder", the result of a high-altitude aircraft disintegration caused by the detonation of a warhead.
By a proper design of the formulation, tablets with a fast disintegration time and a high preservation of bacterial cell viability were developed.
It is found from the physical, mechanical and hydrological experiments that a high degree of alteration causes swelling, disintegration and argillization of rock and soil, and thus weakens physical and mechanical properties of rocks.
A post-compression exposure of tablets to the vapors of appropriate solvents realizes the necessary compaction of matrices, in fact, a high compression force (3 ton) is insufficient, per se, to prevent matrix disintegration in the dissolution medium, whereas such a disintegration is prevented by the treatment with solvent vapors, even with a low compression force (0.3 ton).
Write better and faster with AI suggestions while staying true to your unique style.
Since I tried Ludwig back in 2017, I have been constantly using it in both editing and translation. Ever since, I suggest it to my translators at ProSciEditing.

Justyna Jupowicz-Kozak
CEO of Professional Science Editing for Scientists @ prosciediting.com