The phrase "a height offset" is correct and usable in written English.
It can be used in contexts related to measurements, engineering, or design where a vertical difference is being described.
Example: "To ensure proper alignment, we need to account for a height offset of 10 centimeters between the two structures."
Alternatives: "a vertical displacement" or "a height difference".
For example, the heights of G1 were 3.43 and 3.37 km during UAV5A and D at 07:49 and 08 01 LT, respectively, corresponding to a height offset of − 60 m.
The peaks of echo power corresponding to G1 (G2) were located at the altitudes of 3.43 km (2.93 km) and 3.49 km (2.87 km) during UAV5A and D, respectively, corresponding to a height offset of − 40 m (− 60 m).
The heights of G2 were 2.92 and 2.85 km during UAV5A and D at 07:45 and 08 05 LT, respectively, corresponding to a height offset of − 70 m.
A 1-mm uniform height offset was erroneously, but systematically, introduced between measures of the tissue and reference standard.
The flying height offset caused by wall profile with different shapes can be 8% of total flying height, so it is necessary to consider the effect of pattern shape on etching wall profile in ABS design, especially for ultra low flying height slider.
The significant reductions in standardised catch with increasing spread ratio were hypothesised to reflect either: (i) slightly reduced ground gear contact and headline heights offsetting the greater swept areas; or perhaps more likely (ii) steeper wing angles which increased the probability of mesh encounters and escape for school prawns and were less efficient for herding fish.
The height offsets for G1 and G2 were + 40 and 0 m, respectively, with a time difference of 33 and 25 min.
The annealed spectra are renormalized to have equal peak heights and offset in order of increased annealing time.
The annealed spectra are renormalized to have equal peak heights and offset in order of increased annealing time to clearly show the shifting in peak PL energy that occurred with annealing.
Fin pitch, fin height, fin offset length, cold stream flow length, no-flow length and hot stream flow length were considered as six design parameters.
In fact, when we introduce those lower/higher bounds, we practically define the height and offset of the sinusoidal wave itself.
