The phrase "a height distribution" is correct and usable in written English.
It can be used in contexts related to statistics, biology, or any field where the variation of heights within a population or sample is being discussed.
Example: "The study analyzed a height distribution of the participants to determine the average height and its variance."
Alternatives: "a height range" or "a height profile".
Considering the topography of a surface, the heights of the profile can be sampled to give a height distribution called the amplitude density function (ADF).
In general, there was a height distribution between fibers and also within each fiber depending on the direction of the cross section.
In addition, wire-like nanostructures are also observed on GaAs (311) surface, which also exhibit a height distribution within a range of ~5 nm, as shown in Fig. 2d 2f.
We could not explain the lack of association of adult height with breast cancer by too homogeneous a height distribution, as the interquartile range (139 169 cm) was as wide as that in studies that have found an association (van den Brandt et al, 1997).
(a-3 d-3) height distribution histogra-3 d-3und zero and got sligheightidistributioneposition amount (DA) was increased from ±0.5 to ±2 nm.
where 〈h i, j)〉 is the mean value of heights of the surface, and w is the root mean square roughness and is defined as below [24]: w = 1 N ∑ i = j = 1 N h i, j − h i, j 2 Open image in new window (14) Open image in new window Figure 3 (a-c) height distribution from the AFM images (Figure1).
Indeed, upon depleting centromeric CENP-A nucleosomes using the CENP-B depletion strategy above, ectopic CENP-A nucleosomal arrays derived from SW480 cells display a broad height distribution with an overall average slightly smaller than bulk octamers (2.46 nm, Figure 2, top panel, red; Table 3).
Through such investigation, it becomes clear that the proposed system is usable to design the free forging sequence automatically to forge a slab into a product with an arbitrary height distribution.
A narrower height distribution for the rods was obtained using a pulsed galvanostatic approach then when using a constant current, most likely due to the less favourable diffusion conditions in the latter case.
errors in ionospheric parameters studied by the vertical HF-sounding method were determined for a monotonic height distribution of the electron density.
Another feature of the tool allows for the creation of a histogram (height distribution) from the thickness values representing every pixel of the image (data set).
