This led to a smaller mean TiCx grain separation by the a-C H ma-C H.
Coatings deposited above the racetrack with carbon content ≲ 60% exhibited smaller grains, higher amount of the a-C phase and higher mean grain separation.
Therefore, a mathematical model of the process was developed considering: the rheological properties of a straw layer; the phenomena associated with the dynamic strain of the layer, forced by the motion of straw walkers; and the phenomenon of grain separation from a straw-and-grain mixture.
In contrast, at high Si concentration (5.35 7.00 at.%), larger grain separation, which resulted from the increase of a-SiNx a-SiCx), led to a-SiNx a-SiCxdness to a-SiNx a-SiCxf 13.0–13.6 GPa and a decrease in compressive stress from 4.74 GPa to 2.78 GPa.
Based on the analysis of the relationship between grain separation loss and grain separation flux in an area under the concave, an indirect grain separation loss monitoring method is presented in this paper.
The microstructure can be described as nanocrystalline (Ti,Al N grains separated by an intergranular amorphous BN phase, in which the average (Ti,Al N grain size and grain separation was determined to be 26 and 3 nm, respectively.
Also, the grain size, lattice parameter and the mean grain separation were affected by the energy flux change.
At the same time, grain separation occurs in the feeding zone of the threshing unit if the rotor cage has openings.
The hardness of nanocomposite coatings peaks at the common minimum of the grain size of the crystalline phase and the grain separation.
The simultaneous minimisation of grain losses and the operation time of combine harvester requires, inter alia, the optimal selection of the construction and operating parameters for the straw walker unit, whereas the phenomenon of grain separation and its determinants depending on these parameters are not yet well understood.
Coercive field of the material in general has to do with the size of grain and the grain separation.
