The phrase "a function of rotational" is correct and usable in written English.
It can be used in contexts related to physics, mathematics, or engineering, particularly when discussing properties or behaviors that depend on rotation.
Example: "The torque produced by the engine is a function of rotational speed and load."
Alternatives: "dependent on rotation" or "related to rotational factors".
This paper presents the first reported set of experimental measurements, based on chemical absorption of CO2 in NaOH, of gas liquid interfacial areas and liquid-side gas liquid mass-transfer coefficients in a rotating bed as a function of rotational speed and liquid flow rate.
Supplementary Figure 8 Calculated transverse relaxation rates (R2) as a function of rotational correlation time.
Using a centrifuge, the equilibrium sediment bed height was recorded as a function of rotational speed during the centrifugation.
Analyses of the images were carried out to extract the bed behaviour as a function of rotational speed, drum fill level and particle size.
A straightforward numerical method was used to solve a one-dimensional centrifugation model describing the equilibrium sediment bed height as a function of rotational speed.
a d, R2 for (a) 13CF and (c) 19FC in 3-19F13C Tyr and (b) 13CH and (d) 1HC in Tyr as a function of rotational correlation times (τc) ranging from 5 to 95 ns at a field strength of 600 MHz.
Biomimetic alignment of fibers was achieved as a function of the rotational speed of the cylindrical target during electrospinning of a SF solution blended with polyethylene oxide.
These simulations predicted the percentage of particles remaining as a function of centrifuge rotational speed, indentation size, and particle size, for spherical silica particles against indented substrates made from silicon.
Instead of using complicated equations or charts, simple equations are required to determine the effective length factor directly as a function of the rotational resistant at column ends (GA, GB).
This paper proposes experimental based formulations for modifying the moment rotation plastic hinges of RC columns that have entered the plastic range, introducing suitable expressions of modification factors for stiffness, strength and displacement capacity as a function of the rotational ductility demand.
All comparisons of means were considered significant at the level p < 0.05. Figure 4 shows the raw and normalized CO2 removal rates of the ultra-low-flow CO2 removal device (ULFED) as a function of impeller rotational speed.
