The phrase "a fixed feed" is correct and usable in written English.
It can be used in contexts related to technology, media, or agriculture, where a consistent or unchanging source of information or supply is referenced.
Example: "The system relies on a fixed feed of data to ensure accurate analysis and reporting."
Alternatives: "a constant stream" or "a stable supply".
At a fixed feed flow rate, there is a threshold split ratio, beyond which the recovery drops linearly with increasing split ratio.
Holstein heifers (n = 7 groups, each containing 3 heifers, 3 mo of age), with no previous experience with freestalls, were initially housed on a sawdust bedded pack and fed through a fixed feed barrier for at least 6 wk and then moved to a freestall pen fitted with a head-locking feed barrier.
Simultaneous maximization of product hydrogen and export steam flow rates is considered as the two objective functions for a fixed feed rate of methane to the existing unit.
The smallest AuNPs with the average size of 1.6 nm was obtained at a fixed feed rate of 0.2 ml/min with 4 mM NaBH4.
The use of a fixed interleave between slices is easier to implement, as a standard sequential scan with a fixed feed can be used.
A reduction in the degrees of freedom in the analysis was achieved by using a fixed feed to gas flux ratio to promote a reasonably constant surfactant recovery.
Previous studies both support and oppose the possibility that breakfast omission is compensated for at lunch, with both studies including a mid-morning preload (i.e. a fixed feeding occasion 90 min before lunch).
Because the difference in inhibitor concentrations between feed solutions was expected to affect specific growth rates, implementing a fixed feeding strategy for all propagation conditions would have created disparate cultivation conditions, and consequently, certain adapted cultures would have been cultivated under sub-optimal conditions.
The findings indicate that for performance optimization of an installed LNG train, achieving the lowest specific shaft work together with the highest exergy efficiency is not possible for fixed feed natural gas flowrate and a fixed value of heat transfer coefficient and exchanger area, UA.
A fixed grinding speed, v s = 23m/s, and fixed feed rate, v w = 8m/min, were used, based on the recommendation from the material supplier.
After preliminary modelling using proprietary software, a number of on-grid tests at different flow rates and fixed feed conductivity were carried out.
