Sentence examples for a final surface from inspiring English sources

On top of this, we then laid a final surface.

The surface roughness can be further improved by optimizing the properties of planarizing resist layer and coating processes to enhance the IBP technique as a final surface finishing technology.

With this progressive modelling scheme, a final surface with multiple sub-surfaces can be obtained from a set of unorganised curves and transferred to commercial surface modelling software for detailed modification.

Probably, it can be speculatively inferred that a final surface subsidence of 0.6 m could be regarded as a threshold for determining the critical mining height, e.g., separated backfill mining should be used at the mining height of 3.0 m with surface factor of >0.2, the mining height 4.0 m with the surface factor of >0.15.

At low concentrations (∼100 µg.ml−1) and under conditions where the chaplin peptides are expected to be monomeric each of the peptides behaved similarly, lowering the surface tension by 16 27 mJ.m−2 within seconds and then further towards a final surface tension of ∼30 40 mJ.m−2 over 10 minutes (Table 2).

Similarly, a 0.2-M KClO3 + HF solution led to the etching of polished silicon, which resulted in the formation of Cl2 in solution and a flat final surface.

As a result, the final surface preserves subtle surface variation in the form of tracks and trails that make this approach ideally suited for the production of DEMs used as ground surfaces in immersive virtual environments.

The design is first modeled in some refractory material to within a fraction of an inch of the final surface, and then the final modeling is done in a layer of wax, using the fingers and also metal tools, which can be heated to make the wax more pliable.

Based on an arbitrary input quadrilateral control mesh, a global parameterization of the final surface is first defined through a Gravity Center Method (GCM).

Each KMC simulation was performed a total of 25 times to obtain an average value of final surface coverage for each experimental condition being simulated.

In order to minimize the low-frequency errors in the final surface, a surface-fitting algorithm was used.