The phrase "a density corresponding to" is correct and usable in written English.
It can be used when discussing a specific density that is related to or matches a particular condition or variable.
Example: "The experiment revealed a density corresponding to the temperature changes observed during the reaction."
Alternatives: "a density aligned with" or "a density related to".
NMDA receptors were placed on the postsynaptic membrane within a small circle (350 nm diameter) at a density corresponding to approximately 20 NMDA receptors per synapse (Fig. 1B), consistent with physiological, anatomical, and simulation estimates [46], [47], [25], [32].
In short, isolated colonies were suspended in 3 ml of Inoculum Water (Siemens) until a density corresponding to the McFarland standard 0.5 (≒1.5 × 10 cfu/ml) was obtained.
The base of CTD is abutted perpendicularly to the main axis of the solenoid, with a density corresponding to a sulfate ion buried deep within a highly conserved pocket formed by R380, R425 and K429, all making polar contacts.
From the observation of contour plots, it seems that for a density corresponding to 100% of the density of the cadaveric bone used in this study, the local trabecular bone compaction does not have much impact on implant anchorage because the bone density around the helical blade is already sufficient to provide adequate bone purchase.
On the other hand, in a more osteoporotic femoral head characterised by a density corresponding to 75% of the initial bone density, local bone compaction around the helical blade provides additional bone purchase, thereby decreasing the risk of cut-out, as quantified by the volume of bone susceptible to yielding.
In Section 2.5 we derived two algorithms that can estimate a sample eigenvalue density convolved with a Cauchy density corresponding to a set of population eigenvalues.
On the other hand, a more osteoporotic femoral head with a bone density corresponding to 75% illustrates a case where the use of a helical blade such as the PFNA could decrease the risk of cut-out.
At a cell density corresponding to an absorbance of 1.5 at 600 nm, the temperature was reduced to 18°C, and protein production was induced by mixing the bacterial culture with equal volume of 4°C TB media supplemented with 1 mM IPTG, 100 μM ZnCl2, 50 mg/l Kanamycin, 50 mg/l streptomycin, and 50 mg/l chloramphenicol.
The ultimate physical limitation would correspond to a uniform illumination over the head with a power density corresponding to the safety limits (few mW/mm), combined with a corresponding collection of the emitted signal from the same area with an accepting solid angle of 2π.
Briefly, cells were resuspended to an optical density corresponding to a 0.5 McFarland standard (approximately 1.5 × 108 CFU/mL) and used to inoculate 96-well microtitre plates containing cation-adjusted Mueller-Hinton medium (Becton Dickinson, USA) at colistin concentrations from 0.25 to 128 μg/mL.
Particularly, the cell based on LNCMO-VC delivers an initial discharge capacity of about 136, 129, 122 and 89 mA h g−1 and retained 95.5%, 89.4%, 85.4% and 76.1% of its initial capacity after 100 cycles at a current density corresponding to 0.5C, 1C, 2C and 5C within a voltage window of 3 4.3 V (1C=278 mA h g−1), respectively.
