Sentence examples for a data acquisition device from inspiring English sources
The loading forces were recorded automatically by a data acquisition device of the actuator.
The microgrid will be scanned by a data acquisition device for every half an hour of load demand for a 24-h operation.
A low cost vibrating sample magnetometer (VSM) has been constructed by using an electromagnet and an audio loud speaker; where both are controlled by a data acquisition device.
The sensor electrodes were connected to a data acquisition device (with an input impedance of 100 GΩ in parallel with 100 pF) (NI DAQPad-6016, National Instruments, USA) connected to a computer running a LabVIEW Software, which controlled the measurement.
The independent units are: a) a data acquisition device (DAD) at a remote patient site that is simple, with limited controls and no image display capability and b) an advanced image reconstruction and hardware control multiserver unit at a central site.
An alternative and conceptually similar solution, might include integrating a data acquisition device such as the ultrasound probe used in our case-study with a cellular-phone chip such as, for example Gobi or Snapdragon technologies by Qualcomm (http://www.qctconnect.com/products/snapdragon.html,http://gobianywhere.com/).com/
The typical architecture for such systems is based on a GPS clock generator that is connected to all data acquisition devices via a dedicated fiber-optics link carrying the synchronization clock.
The mobile console (Fig. 1b) contains a hardware data acquisition device, a display and a communication component able to send raw data and receive results.
The Kistler 7257B was connected to a PC using a National Instruments data acquisition device.
The signal was amplified with a custom-made circuit board and digitized with a multifunction data acquisition device (NI USB-6259 MASS Term, National Instruments) [ 44].
A custom LabView programme (V.12.0f3, National Instruments) will be used to control the dynamometer and acquire ankle joint torque, angle and velocity via a USB data acquisition device (NI USB-6259 BNC, National Instruments) at a sampling rate of 1000 Hz.
