The phrase "a conventional frequency" is correct and usable in written English.
It can be used in contexts related to science, technology, or communication, where a standard or commonly accepted frequency is being discussed.
Example: "In radio communications, a conventional frequency is often used to ensure clear and reliable transmission."
Alternatives: "a standard frequency" or "a typical frequency".
Thereafter, the second stage at the BTS performs a conventional frequency selective spatial equalization.
For the sake of simplicity, a conventional frequency beamforming algorithm is used [24].
By slightly modifying a conventional frequency compensation scheme, the PSRR of the BGR is significantly enhanced.
Buffeting responses of the Millennium Footbridge over the Thames River in London, are simulated and the statistics of the results are compared with a conventional frequency domain method.
In contrast to conventional spectrum-sliced optical architectures that operate on the basis of a finite number of discrete taps, our proposal is based on arbitrary shaping of the spectrum of the broadband optical source in a conventional frequency encoder.
Then, a combined high and low-frequency ventilation was initiated (VDR4 percussion ventilator, Reiner, Germany) with a percussion frequency of 400/min and a conventional frequency of 10/min.
The load mismatch for each area is shown in Fig. 4; the load mismatches were backwards calculated based on an actual 2011 Swiss frequency signal in such a way that conventional frequency control resulted in a response very similar to the measured frequency data.
The relative gain of a scheme over the conventional frequency reuse scheme in this case is defined as Relative gain =, where is the sum rate of the considered scheme (Coop or FFr).
Moreover, UWB antennas for portable consumer electronics and mobile communications applications have different requirements than those intended for fixed-point communications or broadband testing; as a consequence, many of the conventional frequency independent and log-periodic designs are not suitable.
The operation in time domain leads to a significant complexity reduction relatively to the conventional frequency domain processing because the MMSE filter corresponds to a sparse diagonal matrix, as was extensively discussed in [26].
The conventional frequency estimator uses a zero-crossing algorithm (ZC), but this approach fails at low flows, where the signal-to-noise ratio is poor.
