Sentence examples for a constant depth and from inspiring English sources

That study had a significant impact in the field, because he also provided analytical results for what he referred to as the canonical problem, i.e., a solitary wave propagating over a constant depth and then running up a sloping beach.

Both this method, and the conventional method, are applied to the canonical problem of a solitary wave propagating over a constant depth and then up a sloping beach (Synolakis, 1987).

Because of the nonlinear dependence of the sea surface height on the water depth, a linearized analysis is performed concerning the identification of a Gaussian bump within two specific depth profiles, (1) a constant depth domain, and, (2) a constant depth domain adjoining a near-resonant continental shelf.

As highlighted in Section 2.3 each layer is modelled by a constant depth plane and a contour on one of the image viewpoints.

Their spindles remain at a constant depth in the cell and consequently can be observed in a single focal plane.

Twenty-five cells per slide were randomly captured at a constant depth of the gel, and mean tail length was calculated to measure DNA damage by using Comet Score 1.5 Software (Comet Score v1.5 Software, TriTek Corporation, Sumerduck).

The experiments were conducted at three different cutting speeds (80, 100 and 120 m/min) with three different feed rates (0.04, 0.08 and 0.12 mm/rev) and a constant depth of cut (0.5 mm).

The proposed concept can be described by producing a metal like-composite where a hard phase incorporates in these tubes made by case-hardening of 15% of tubes outer surface with different geometrical shapes and a constant depth along the tubes thickness.

Seismic data collected in 2011 suggested that the décollement steps down into a local graben at the trench axis (Kodaira et al. 2012; Nakamura et al. 2013) rather than remaining at a constant depth above the overriding plate and 'bulldozing' the sediment from the top of the incoming horst blocks (e.g., Hilde 1983).

The turning performance in terms of cutting force and cutting temperature was evaluated under three levels of cutting speed and two levels of feed rate and at a constant depth of cut.

The equations describing temperature distribution inside cylindrical work piece, rate of heat transfer, net residual heat for a constant depth of cut are also computed and presented.