The phrase "a complete dissolution of" is correct and usable in written English.
It can be used in contexts discussing the total breakdown or termination of something, such as an organization, relationship, or agreement.
Example: "The board voted for a complete dissolution of the partnership after years of conflict."
Alternatives: "an absolute termination of" or "a total breakdown of".
In my London Evening Standard column yesterday, I argued that the disconnect between the BBC's executive and the BBC Trust "could be cured without bringing about a complete dissolution of the Trust".
Conversely, irradiations performed at room temperature using Au ions lead to a complete dissolution of the oxide particles, in agreement with the estimation of ballistic vs. radiation enhanced diffusion effects.
A clear solution was obtained by incubating a complete dissolution of the surfactant.
Nevertheless, too long etching leads to a complete dissolution of the small SiμG.
Krieger's conflicting commitments to the historicist conception of history and to universal values resulted in fear that historicization would lead to a complete dissolution of historical coherence and meaning.
Results of the dissolution experiments in H3O+ medium proved to be congruent, since in most of the cases, a complete dissolution of the solids was reached, and the K+, Fe3+, SO4 2− and CrO4 2− concentration in the remaining solution is stoichiometric according to the initial solid amount.
Due to the presence of the hydrophilic glycolide units into the PLA polymer (50 50 molar ratio), in the case of NPs formulated with PLGA a completed dissolution of Dtx is achieved within the first 2 hof the test.
However, a less complete dissolution of thrombus in conjunction with a greater amount of embolic debris is achieved with this approach.
Our patient developed a localised infection with a significant concomitant osteolysis and an almost complete dissolution of part of the ulnar diaphysis.
Meantime, a nearly complete dissolution of the intermetallic phase Mg17Al12 in the melted layer is observed, leading to the formation of a super-saturated solid solution on the surface.
When a complete dissolution was achieved, an aqueous solution of the catalyst (copper II)) was added under pH control and stirring.
