Sentence examples for The residual section from inspiring English sources

The residual section of Parwan remaining in US control is "absolutely more secretive" than Guantánamo, said Tina Foster, a lawyer and executive director of the International Justice Network, one of a select few to attempt representation of the non-Afghans at Parwan.

The analysis shows that the Ridgelet transform had an adverse effect on the inclined features as observed in Fig. 10c (where the residual section contained the energy of inclined features ).

The results allow describing the different timbers utilised, the state of preservation, mechanical and biotic decays and finally to determine the present strength of each wooden element, obtained through the combination of the evaluation of the defectiveness and the measurement of the residual sections.

The successful capture of IPCs was demonstrated by the absence of GFP-labeled tissue from the residual sections.

Figure 10b d show the reconstructed seismic section from the filtered Ridgelet coefficients, residual section and reconstructed seismic section after the application of the wiener filter, respectively.

However, it was considered that the anatomical resection of the residual anterior section would be difficult and that there would be a risk of causing new bile leakage due to the presence of dense adhesions and the anatomical modifications of the liver in the second previous hepatectomy.

The results showed that the residual cross-section shape and the amount of cross-section loss had considerable influence on the ductility of the bars.

The load-bearing capacities of the corroded beams were assessed using the measured mechanical properties and the residual cross-section of the bars according to different failure mechanisms.

Through the tests, besides the corrosion degree, which was the most often used parameter to assess the corrosion, the corrosion morphology (i.e. represented by the radius of gyration of the residual cross-section) was found to be a very important factor influencing the ductility of the steel reinforcement and three typical corrosion morphologies were identified.

The results show that residual sections can be simplified into ellipses for general corrosion; otherwise, it can be ascribed to combined pit and general corrosion.

Section  9.2 studies the influence of equivalent choices of the mesh-size function h (T ) for the residual error estimator, Section  9.3 concerns a facet-based formulation of η, while Section  9.4 analyzes recovery-based error estimators.