Next in order of diminishing strength were Calcibon® and Norian SRS® (33.95 ± 6.75 and 25.64 ± 7.37 MPa, respectively), which was statistically significantly higher than most other products.
Next in order came Actuality, Torsion and Close Image.
Next, in order to control bifurcation and chaos in these converters, the ramp compensation method is used.
Next in order to estimate the parameters of the linear block, the evaluation of the inner unmeasurable signal is considered.
Next, in order to achieve a stable drive of the active vibration isolation system, a method of using a low gain dynamic compensator is offered.
Next, in order to test the potential of this material for micro-manipulation devices, a pair of duobimorph cantilevers is used to build a microgripper.
Next, in order to simulate the reoxidation reaction, the anode was subjected to forced expansion, and the residual stresses were estimated at high temperatures.
Next in order to avoid state estimator design, BSC and GLC are designed based on pH reduced order model and their identities have been established.
Next, in order to develop a guide for future practitioners, an analysis is conducted of the most suitable valuation methods for the respective ecosystem service impacts.
Next, in order to determine the characteristics of a full-scale device through model tests, besides geometrical similarity, similarity of dynamical conditions between the two is also necessary.
