In these measurements, adhesion was measured after 8 min in contact.
In these measurements on land, the weights of the samples for all analyses were measured, and the concentrations are represented in units per kilogram.
In these measurements, we use a R S =10 Ω shunt resistor.
In these measurements, all the samples were diluted five times with water.
In these measurements of low activity sources, the dead time is always less than 3%.
In these measurements a detection limit of 3 nM is resulted for both compounds.
In these measurements, we focused on observing the end-to-end communication delay between two sensor and actuator devices.
In these measurements, we used a red light-emitting diode (LED) as a source of the optical radiation.
In these measurements, the boron concentration was determined from the strain compensation of intrinsic and boron-doped SiGe layers.
In these measurements, the QD was set to 70 V for selection of 510 nm particles, and to 400 V for 990 nm particles.
In these measurements, the receiver is kept fixed at channel 6 (center frequency at 2437 MHz) and the interferer sweeps from channel 7 to channel 12.
