Sentence examples for I current from inspiring English sources

i current density (A m−2).

(b) Statistical distributions of the generated output (i) current and (ii) voltage by Gaussian fits.

Hence, we implemented the following double-control strategy: i) Current mode control with two nested loops (current and voltage feedbacks) in normal conditions for better regulated performances   ii) Hysteretic control in case of low load current for low-power operation  .

Fifteen questions were formulated in relation, among others, to: (i) current and future injury prevention behaviour; (ii) needs and support for the intervention; (iii) characteristics (content, form) of the intervention; and (iv) strategies to deliver the intervention.

In order to estimate the performance enhancement of samples, the statistical distributions were figured out by Gaussian fits from the measured values of the generated output (i) current and (ii) voltage in Figure 5b.

The paper first substantiates the need to develop a long-term research plan for barriers, traps, and fishways by summarizing (i) current management challenges, (ii) the barrier, trap, and fishway options being used to meet these challenges, and (iii) the key uncertainties in our knowledge regarding these options.

Using satellite data to obtain the field-aligned current, they showed that the change in the location of the magnetosphere-ionosphere (M-I) current system depends on the F10.7 index and suggested that this could be the cause of the low Sun-Earth coupling during 2009.

If the shift of M-I current system with low ionospheric conductivity is the major reason for the uniqueness of year 2009, the effect should be more obvious in the high-latitude geomagnetic disturbances (AL index) than in the low-latitude geomagnetic disturbances (Dst index).

The relative target protein concentration of the selection step was lowered each round in response to the S/B ratio as follows (Eq. 1):

For the information-driven screening, we define sMPAS for gene G i in current evaluation set as the difference between the sMPI scores without and with G i, that is, sMPAS (G i, X (I ) | current genes ) = Δ sMPI (X (I ) ) (G i removed ).

To calculate the heat input for arc welding procedures, the following formula can be used: Q = \left(\frac{V \times I \times 60}{S \times 1000} \right) \times \mathit{Efficiency} where Q = heat input (kJ/mm), V = voltage (V), I = current (A), and S = welding speed (mm/min).