After fabrication, the samples were rinsed in DI water and dried in air.
After fabrication of 2D nets, RIE was used to induce Sn grain coalescence.
After fabrication, the entire surface was covered with a thin layer of releasing film.
After fabrication of microvalves, we evaluated the frequency characteristics and pressure resistance of the microvalves.
After fabrication and assembly the design is statically tested and compared to the predicted model performance.
After fabrication, the 2D electrode channel array is rolled into a 3D channel bundle fitting the peripheral nerve.
After fabrication onto aminosilane-coated slides, hybridization conditions of the array were optimized for high specificity and signal intensities.
After fabrication, the devices following this design can be successfully internalized inside living macrophages without affecting their viability.
After fabrication, an optical microscope (Nikon eclipse LV100, Nikon Instruments Inc., Melville, NY, USA) is used to identify MoS2 flakes at first glance.
After fabrication, all samples were annealed at 400 °C for 30 min with a temperature ramping rate of 15 °C/min.
After fabrication of glass fiber/epoxy composites, tensile, compression, and flexural properties were tested by UTM by room and high temperature.
