Sentence examples for 1 piping from inspiring English sources

The program, named 'HITEP_RCC-MRx,' is composed of two modules: 'HITEP_RCC-DBA,' which computerizes the design-by-analysis (DBA) for class 1 components according to RB-3200 procedures, and 'HITEP_RCC-PIPE,' which computerizes the design-by-rule (DBR) analysis for class 1 piping according to RB-3600 procedures.

Accordingly, the frequency of coolant leakage from Class 1 piping was calculated using a probabilistic fracture mechanics (PFM).

The LBB has been applied to the design of Class 1 piping in Japanese light-water reactors.

In this paper, an analysis procedure is introduced to enable a general piping software to conduct ASME III class 1 piping analysis with non-uniform wall thickness.

The results of this analysis indicate that the frequency of coolant leakage from Class 1 piping is less than the expected occurrence of an S1-earthquake.

In ASME B&PV Code, Section III, Subsection NB-3600, thermal stratification is not taken into account to determine the peak stress intensity range for fatigue design of nuclear class 1 piping.

The good news for bird enthusiasts is that 73 piping plovers were successfully fledged in 2005 and, guess what, some seem to have a little bit of homing pigeon in them.

Difficulty: medium complexity Makes: 10 Preparation: 40 mins, plus cooling Cooking: 25 30 mins Special equipment: 2 piping bags, 1.5cm and 5mm plain nozzles Planning ahead: You can prepare, cook and freeze the éclairs in advance; defrost 1 hour before needed, then fill and glaze them.

The numerical results indicate that the guide vane at the right location is effective in reducing vibration and flow-induced noise in the 90° piping elbow with water.

The main goal of this paper is to investigate the cyclic behavior of the X60 piping steel under cyclic extreme loading conditions, also covering the respective monotonic ductile and low-cycle fatigue behaviors.

In the Korean Next Generation Reactor (KNGR) developed as an ALWR, a typical piping model was selected to include ASME Classes 1, 2 and 3 piping and was analyzed according to the current method as well as the alternate analysis method, specified in NUREG-1462, for comparison.