Sentence examples for 1 peg from inspiring English sources

After dispersion of silver ions in the PEG aqueous solution matrix (Equation 1), PEG reacted with the Ag to form a PEG complex [Ag PEG]+, which reacted with sugar to form [Ag PEG)] due to the reduction of silver ions through the oxidation of sugar to gluconic acid (Equation 2).

Open image in new window Fig. 1 PEG calibration curve for molecular weight distribution.

Low-density distribution of biotin-PEG-NH2 biotin-PEG-NH2 biotin-PEG-NH2 that at monthe PEG columnbe conjugated to an activated PrA molecule, whereasurfaceiensuredumn-based purificathat atded in quick remostl of unconjugated PrA.

The pattern consists of three tiers; the period grating (1 PEG bar + 1 lipid bar) increases by 2 n micrometers, where n is a natural number, for bars below 10 μm, by 20 n micrometers for bars between 10 and 100 μm, and by 200 n micrometers for bars between 100 μm and 1 mm.

Three types of hydrogels were used in these experiments that were all molded as alternating ridges and grooves over the surface of the 400 nm pitch topographically patterned substrates: (1) PEG hydrogel (biologically inert), (2) bioactive heparin hydrogel (without fibroblasts), and (3) heparin hydrogel with embedded fibroblasts.

The following four groups of hydrogels were prepared for RIN-m5F encapsulation: (1) PEG-only hydrogels; (2) PEG hydrogels copolymerized with 2.5 mM of laminin-derived cell adhesive peptide IKVAV; (3) PEG hydrogels copolymerized with 10 μM GLP-1C; and (4) PEGDA hydrogels copolymerized with 2.5 mM acryl-PEG-IKVAV and 10 μM GLP-1C.

Three children discontinued treatment for refusal due to bad taste of the product (1 PEG-only, 2 PEG-EL); 1 (PEG-EL) for an adverse effect (abdominal pain).

Four children dropped out; 3 of them (1 PEG-only, 2 PEG-EL) due to the bad taste of the product; 1 (PEG-EL) for an adverse effect.

Figure 1 depicts a best-fit line for total doxorubicin concentration time data in patient #1 (PEG-LD 8 mg m−2) during cycles 1 and 2. Maximum-likelihood analysis was updated and two iterations were required to achieve stable estimates of the median parameters.

The following conditions yielded the FtsZ crystals: 30% PEG 200, 100 mM MES pH 6.0, 5% PEG 3000.

The initial point of our ATPS corresponded to 2.5% PEG 35 000 and 3.2% DEX 500 000.